Stack snail sludge dehydrator is often blocked how to do? Today, we will give you an analysis from the following points, hope that through our introduction to let you find and solve the problem in a timely manner, below we will learn about it in detail, as follows:

The first reason is that no filter device is added before the main body of the dewatering machine, and the debris is entered. Generally, a filter net is installed in the flocculation tank to isolate plastic bags or leaves.

Reason two, the design of spiral axial compression ratio of stacked screw sludge dewatering machine is unreasonable, and the dewatering part is under too much pressure.

Reason three, the gap between the back pressure plate of the sludge outlet of the stack snail sludge dewatering machine is too small, and the sludge can not be discharged normally.

Reason four, the static ring and spiral shaft wear too much, resulting in the deformation of the spiral and dynamic ring, which is mainly because the static and dynamic ring has not been strictly levelled, the flatness error is too large, resulting in the friction between the spiral and dynamic ring can not withstand the load in the short term, until the deformation and scrap.

If you encounter the problem of clogged sludge dewatering machine can be investigated one by one, if there is a need, you can also call our hotline, we will answer you in time